MIP 18390 X-Duty Rear CVD Drive Kit FOR Traxxas Bandit Fiesta ST Rally 12mm

MIP X-Duty Rear CVD Drive Kit FOR Traxxas Bandit / Fiesta ST Rally

Part Number: MIP18390 / 18390
Brand: MIP
Position: Rear
Material: Heat-Treated Carbon Steel
Wheel Hex: 12mm

The MIP 18390 X-Duty Rear CVD Drive Kit is a heavy-duty aftermarket drivetrain upgrade designed FOR Traxxas Bandit and Fiesta ST Rally vehicles.

Built from high-grade carbon steel with heat-treated components, the MIP X-Duty system replaces the factory composite rear driveshafts with a significantly stronger, fully rebuildable steel drivetrain. The components feature a black oxide coating to help protect against premature corrosion while providing the durability needed for high-power brushless setups, drag racing, and aggressive driving.

Application / Compatibility

Designed FOR:

• Traxxas Bandit
• Traxxas Fiesta ST Rally

Fiesta ST Rally: Direct fit with no modification required.

Bandit: Compatible, but installation requirements vary depending on the rear hub configuration. See important fitment information below.

Features

• Genuine MIP X-Duty Drivetrain Upgrade
• Designed FOR Traxxas Bandit & Fiesta ST Rally
• Heavy-Duty Splined Steel CVD Construction
• High-Grade Carbon Steel
• Heat-Treated Components
• Black Oxide Protective Finish
• Replaces Factory Composite Rear Driveshafts
• Up to 4S LiPo Certified
• Fully Rebuildable Design
• Heavy-Duty 12mm Keyed Wheel Hexes
• Excellent Upgrade for High-Power Applications
• Popular Upgrade for RC Drag Racing
• Complete Left & Right Rear Drivetrain
• Designed, Manufactured & Packaged in the USA

Includes

• (2) MIP X-Duty Rear CVD Assemblies
• (2) 12mm Hex Adapters
• Bearing Spacers
• Required Assembly Hardware
• MIP Lube & Thread Gel
• Instructions

⚠️ IMPORTANT – BANDIT FITMENT

When installing on a Traxxas Bandit, MIP recommends ball-bearing rear hubs for optimum performance.

Recommended components include:

• Traxxas 3752 Rear Hubs
• Traxxas 5116 Bearings

The included X-Duty system uses a 12mm keyed wheel hex. Compatible 12mm hex wheels are required.

Depending on suspension setup and rear hub position, minor clearance modification of the suspension arm may be required to allow the X-Duty CVD bell to rotate freely.

Fiesta ST Rally

For the Traxxas Fiesta ST Rally, MIP specifies the rear kit as a:

DIRECT FIT – NO MODIFICATION REQUIRED.

The corresponding MIP front CVD kit is Part #19390, sold separately.

⚠️ MAINTENANCE

For maximum drivetrain life:

• Use MIP grease during assembly
• Use MIP thread gel/thread locker where specified
• Keep CVD joints properly lubricated
• Periodically inspect pins and joints for wear

⚠️ AFTERMARKET PRODUCT

THIS IS AN MIP AFTERMARKET PRODUCT DESIGNED FOR USE WITH COMPATIBLE TRAXXAS VEHICLES.

THIS PRODUCT IS NOT MANUFACTURED BY TRAXXAS.

Traxxas, Bandit and Fiesta ST Rally names are used only to identify vehicle compatibility.

Important

THIS LISTING IS FOR ONE MIP #18390 REAR X-DUTY CVD DRIVE KIT ONLY.

Vehicle, wheels, tires, rear hubs, bearings, front CVDs and other components are NOT included unless specifically listed above.

Pictures are for reference only.